IM2X20700 MosMax dual 20700/21700 battery tray/holder/sled injection molded

Description

You get:
(1) Battery Tray
(4) Contacts
IM2X20700 by MosMax Electronics is a nylon injection molded (not 3d printed...) dual battery tray designed to fit either 20700 or 21700 cells (21700s will over hang the tray about 1mm over the left & 1mm over the right sides - allow extra space/width for 21700s).
For use with flat top/unprotected batteries only. Button top/protected batteries will be too long to fit properly.
Dimensions (in mm) of tray are 84.7L x 41W x 18.4H wire channel is 3.8 diameter. Thicknesses up to 14 gauge silicone insulated wire should fit in the underside channel.
Contacts included are Keystone 228 & 209. These contacts can be placed for either series or parallel battery configurations. Contacts can be soldered to while clipped in place, just be careful not to dwell with for an excessive amount of time or with excess heat. Flux can be cleaned up with acetone or alcohol without damaging the tray.